Installation and Compatibility

Please Use a Qualified Local Installer

Our vehicle lighting products, especially projector headlight modules and Bi-LED projectors, can involve complex installation and wiring. Please have the work carried out by a qualified local automotive workshop or automotive lighting specialist. Do not treat a projector retrofit as a simple bulb replacement.

Before You Order

Ask your installer to check your vehicle make, model, year and headlight configuration; the product dimensions and mounting space; operating voltage and wiring requirements; connector compatibility; and any additional adapters or control modules your specific vehicle may need.

For low-beam projector products, confirm the correct beam pattern for the side of the road on which you drive. Product appearance or nominal lens diameter alone does not establish compatibility.

Check the product listing for the exact contents supplied. Wiring harnesses, switches, brackets, adapters, sealant or vehicle-specific parts are included only where the listing says so. Installation services are not included unless expressly stated.

Projector Headlight Installation

Depending on the vehicle and product, a retrofit may involve opening the headlight assembly, adapting mounting points, routing and connecting wires, integrating high-beam control, and resealing the housing. The installer should follow the product instructions and the vehicle manufacturer's relevant service procedures.

Proper sealing, wiring protection, mounting and heat clearance are essential. After installation, the installer should check electrical operation, high and low beam functions where applicable, and beam alignment using suitable equipment.

Auxiliary Lights and Motorcycle Lights

Have your installer check mounting security, clearance from moving or hot parts, full steering movement and wiring protection. Use the correct electrical protection and components for the product and vehicle. Do not obstruct cooling, vehicle controls or required lighting.

Check Before Permanent Modification

Have your installer inspect the product and carry out any appropriate safe functional checks in accordance with its instructions before permanent wiring changes, drilling or final resealing. If something appears incorrect or faulty, stop and contact [[SUPPORT_EMAIL]].

Road Use and Local Requirements

Lighting requirements vary by country, vehicle and application. Compatibility and professional installation do not by themselves establish road legality. Do not assume that a product is approved for public-road use, has a particular DOT or E-mark status, or will pass a vehicle inspection unless the specific product documentation supports that use in your location. Products described as off-road only must be used accordingly.

Installation Damage and Warranty

Our one-year limited commercial warranty covers manufacturing defects. Damage caused by incorrect installation, wiring, resealing or misuse is excluded from that voluntary coverage, to the extent permitted by law. Independent installation does not automatically cancel coverage for an unrelated manufacturing defect. See our Warranty Policy for details.